What should the tension be on a Brother embroidery machine?

When doing machine embroidery, the tension dial should be set somewhere between 2 to 6. If the stitches appear loose, turn the tension up one notch and embroider again.

Why does my thread keep breaking on my brother pe770?

The upper thread tension could be set too tight. Set the tension to the best thread tension setting or less. Make sure the spool of thread is installed correctly using the correct size spool cap for the size of spool.

What thread tension should I use?

So we’ll be talking only about the top thread tension since that’s where you’d usually make the adjustments. The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics.

What tool I will use to adjust top embroidery tension?

Tajima thread tension gauge
Tajima thread tension gauge enables embroiderers to measure and adjust top thread tension on both commercial and home machines. The tension gauge is hooked to the top thread from the presser foot and by pulling on the thread the embroiderer can determine the tension the embroidery machine is exerting on the thread.

What number should tension be on sewing machine?

As the bobbin thread tension is factory-set and wouldn’t usually be adjusted for normal sewing. So we’ll be talking only about the top thread tension since that’s where you’d usually make the adjustments. The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing.

Why Does My Brother sewing machine keep coming unthreaded?

1. The upper thread was not threaded correctly. The spool is not installed correctly, the spool cap is too big for the spool being used, or the thread has come out of the needle bar thread guide. Rethread ensuring that the spool is installed correctly and using a spool cap that matches your spool size.

Why does my thread keep breaking brother?

The upper thread tension could be set too tight. Set the tension to the best thread tension setting or less. Make sure the spool of thread is installed correctly using the correct size spool cap for the size of spool. Check that the bobbin is wound so that it about 80% full and that the thread is evenly wound.

How to remove tension thread from brother pe770?

Main unit Thread tension mechanism AT pulse motor removal 1. Remove the 2 screws 1, and remove the AT pulse motor 1. Tension disk removal 1. Remove the screw 1, and remove the initial adjustment plate 1. 2.

How to adjust the bobbin tension-brotherusa?

The bobbin case installed in this machine can be adjusted, if necessary, to accommodate the bobbin tension for embroidering. 1. Using a small slotted screwdriver, turn the slotted head (-) screw to adjust the bobbin case tension. Do not turn the phillips screw (+).

How to remove timing belt from brother pe770?

Remove the 2 screws 1, and then remove the connector holder assembly 2. Remove the 2 retaining rings (E2), and then remove the lead wire assembly (main body FCOMB) 2, ES pin F-A 3, and ES pin F-B 4 from the connector holder assembly 1. Main unit Electrical parts and motors Timing belt (motor belt) removal 1. Remove the timing belt 1.

What should the tension be on a bobbin?

Bobbin thread appears slightly on the right side of fabric. – If this occurs, turn the slotted-head screw (-) clockwise, being careful not to over-tighten the screw, approximately 30-45 degrees to increase bobbin tension.