Can you twin stick a Dana 20?
Can you twin stick a Dana 20?
The good news is that there are plenty of aftermarket twin-stick shifters available for the Jeep Dana 20. An aftermarket twin-stick shifter conversion can simplify shifting and offer transfer case modes not available with the original single-shifter mechanism, such as two-wheel-drive rear low range and front only.
How do I know if I have a Dana 20 transfer case?
The Dana 20 is a cast iron transfer case, having a passenger-side front output and a centered rear output. It has the same “Texas” front mounting input flange as does the Dana 18. Markings on the Dana 20 can vary, but most start with a C18-15-24… Some confuse them for a large case Dana 18 because of this.
How much does a Dana 20 transfer case weigh?
Dana 20 Specs
| Manufacturer: | Dana-Spicer |
|---|---|
| Weight: | ~ 80 lbs |
| Yokes: | 1310 front and rear output yokes, fixed |
| Fluid Type*: | OEM fluid requirements varied, 80w-90 gear oil is typical |
| Fluid Capacity: | 2.75 pints (1.375 quarts) |
Is the Dana 300 a good transfer case?
The Dana 300 is arguably the best factory transfer case offered in a 4-wheel drive. Yes, an NP205 is stronger and is available in either left- or right-hand drop, but it is also heavier and larger and only offers a 1.96:1 low range.
What is a Dana 20 twin stick?
Stainless Steel Dana 20 Twin Stick Kit. This kit allows you to separate your forward gears from the rear gears, allowing you to do a front-only dig or a rear-only dig, or both together.
How does a twin stick transfer case work?
Twin stick shifters allow independent control of the high/low and 2wd/4wd sections of your Toyota gear driven transfer case. This allows access to low range 2wd operation. It also allows you to shift in and out of 4wd while driving on the trail without the need to stop.
What is AJ shifter?
TRANSWORKS IS PROUD TO BE A DEALER FOR THE AJ SPEED SHIFT SYSTEM, THE SLICKEST SHIFTING SYSTEM EVER INVENTED. IT CONVERTS ANY TYPE I VW, MENDEOLA MD4-E, OR MD4-2D TO A SEQUENTIAL SHIFT PATTERN, LIKE A MOTORCYCLE. IT IS A HYDRAULIC UNIT THAT IS ESPECIALLY NICE FOR MID ENGINE APPLICATIONS.
Are there universal parts for the Dana 20 transfer case?
Some parts may be universal, but many Dana 20 transfer case parts such as the manual trans output shaft gear are proprietary and can be used with only this T-case. Use the Dana 20 transfer case diagram to ensure components match.
What do I need for a Dana Spicer transfer case?
If you are looking for OEM Jeep Replacement Dana Spicer Model 20 Transfer Case Parts or want to upgrade your dana 20 parts we have everything from output shafts, bearings, yokes and seals that you will need! OMIX 16580.04 Yoke for 41-79 Jeep Vehicles with Dana Spicer Model 18 or Model 20 Transfer Case – 26 Spline.
What kind of transmission does a Dana 20 have?
A sliding output gear acted also as the output shaft coupler to the input gear’s clutch (“bull”) teeth. The Dana 20 is a cast iron transfer case, having a passenger-side front output and a centered rear output. It has the same “Texas” front mounting input flange as does the Dana 18.
What kind of shift kit do I need for Dana Spicer?
Remote style “J” shift versions are problematic. Some versions will offer challenges in conversions to other vehicles or transmissions. Upgrading to an aftermarket shift kit, like this twin-stick shifter kit, is a good idea for many situations. There are OEM (shown) and aftermarket versions of TH400 to Dana 20 adapters.