Are 454 and 350 motor mounts the same?

They are all the same. All mounts will have the bolt location in the same spot. If there is a difference it will be in the frame and not in the mounts.

Are 327 and 350 motor mounts the same?

Registered. 327 and 350 frame mounts on a first gen. are different. They position motor differently and can cause header or distributor clearance issues.

Will an Allison transmission bolt to a 454?

It would bolt up to the 454. Hope this helps some. Old trucks and old trailers . . . a comfortable combination!

Will a SM465 bolt up to a 454?

The SM465 is plenty strong enough for a 454.

How much did a Chevelle cost in 1970?

Detailing

What was the engine mount on a 1964 Chevelle?

Many 1964-1967 engine mounts (both small block and big block) were eventually replaced with engine mounts featuring a lock tab that would restrain a broken mount keeping the engine from lifting off the frame stand. Comparison of non-locking engine mount (top) and later locking engine mount (bottom).

What was the problem with the early Chevy engine mounts?

Early Chevrolet engine mounts had a tendency to separate the metal plate from the rubber. This could, and sometime did, result in the driver side of the engine lifting due to engine torque and jamming the accelerator in the open position.

What kind of engine does a 1969 Chevy Chevelle have?

Although shown here on a 1969 396 engine these are only listed in GM’s parts book for 1968 and 1969 Chevy passenger, Chevy II, and Camaro; they are not listed for Chevelles which is odd since 1968 saw the introduction of the throttle cable linkage in lieu of a solid rod used up through 1967.