What is DDR3L speed?

DDR3L (1.35V) 800 (DDR3-800) PC3-6400. 6400 MB/sec.

Can you put DDR3L in a DDR3 slot?

DDR3L modules are backwards compatible with DDR3 by design. Manufacturers use the same integrated circuits for DDR3 and DDR3L. The highest quality ICs are tested for operating at 1.35 volts and are branded as DDR3L if they run properly. Other than that, there’s no difference between them.

At what voltage does DDR3L run?

DDR3L is pin-compatible with DDR3. DDR3L is a dual voltage capable memory SoDIMM, which supports operation at both 1.5 V and 1.35 V.

What is DDR3 1333mhz?

Designed for todays systems which support DDR3, the primary benefit of DDR3 is the ability to transfer data at a much higher rate than DDR2 due to the higher clock rate. This allows you to take advantage of the high speeds of todays CPU’s.

Can I use 1.35V instead of 1.5 V RAM?

thanks for your reply if you could. 1.35 volt (DDR3L) memory and 1.5 volt (DDR3) memory are identical. Manufacturers simply select higher quality modules and configure them as 1.35 volt nominal. All DDR3L modules are fully backwards compatible with DDR3, meaning that 1.35 volt memory will run just fine at 1.5 volts.

Should I use DDR3 or DDR3L?

The older DDR3 operates at a single voltage power of 1.5, which ensures a solid and fast performance. In contrast, the DDR3L module uses less voltage power, which ensures that the chip will operate at a much cooler temperature, which means that the DDR3L has a lower risk of overheating out of the two.

Can I install 1.35V RAM instead of 1.5 V?

Will the dual voltage 1.35V/1.5V parts work with my original memory? In order to run at 1.35V, all installed memory modules must be dual-voltage 1.35V/1.5V and the system must support DDR3L (1.35V low voltage) to enable the module to run at 1.35V.

Can I mix 1.35V and 1.5 V memory?

These 1.35 V parts can operate at 1.5 V when mixed with the 1.5 V DIMMs in a supported configuration.

Can I replace 1333mHz RAM with 1600mHz?

The compatibility of the ram depends more on your motherboard than your cpu. If your motherboard supports the 1600mHz, then it is likely that the g3258 will also. However, the cpu spec sheet says that it only supports up to 1333mHz, so if you use 1600mHz sticks it may downclock them to 1333mHz.

What is the maximum clock speed for DDR3 RAM?

The clock speed of DDR3 vary from 800 MHz to 2133 MHz, where 2133 MHz is its peak in some cases, generally clock speed is varying between 1600 to 1800 MHz. In DDR4, only self-refresh is performed to refresh its content that’s why it consumes less power. The minimum clock speed of DDR4 is 2133 MHz and it has no defined maximum clock speed.

What is the maximum transfer rate of DDR3 SDRAM?

With data being transferred 64 bits at a time per memory module, DDR3 SDRAM gives a transfer rate of (memory clock rate) × 4 (for bus clock multiplier) × 2 (for data rate) × 64 (number of bits transferred) / 8 (number of bits in a byte). Thus with a memory clock frequency of 100 MHz, DDR3 SDRAM gives a maximum transfer rate of 6400 MB/s.

Which is better DDR3L or ddr2l memory?

As an older model, DDR3 memory is much cheaper than DDR3L ones. DDR3 memory is compatible with a wider and older generation of processors. These memories are largely available in the market, as opposed to the DDR3L models which are rare. The data transfer rate of DDR3 and DDR3L memory is quite the same.

What’s the double data rate of DDR3 memory?

Double Data Rate means that this memory transfers data on both the rising and falling edges of the clock signal. This is why 1600mhz DDR3 memory appears as 800MHz in cpuid. This is the current type of memory used in modern systems.